Hired-Hand RollSeal Sidewall System (Curtain): SideWall Curtain - Manual (Page 10)

Part No. 4801-5072 Rev 9-08 SideWall Curtain Page 10
Install bottom channels underneath track
units.
Note that bent edges of bottom channels
point downward.
Figure 7
Bottom channels
8.5 Bottom channels
Refer to Fig. 7. The bottom channels attach underneath the vertical members (left track, right
track and center track units). Starting at the left end, install the bottom channels.
1. Insert a bottom channel underneath the vertical members as shown in Fig. 7. The bent edges
of the bottom channels point downward. Align the larger flange of a bottom channel against
the face of the bottom board. Align the bottom edge of the bottom channel flush with the
bottom of the 2"x 6" board.
2. With bottom channel oriented as described in step 1, align screw holes in front flange of
bottom channel with bottommost screw holes in the vertical members.
3. Install screws to attach bottom channel to vertical members. Leave screws loosely attached
so that bottom channel has freedom of movement. Do not fasten bottom channel to
bottom board at this time.
4. Repeat steps 1-3 to install all bottom channels to vertical members.
End of bottom channel should
be flush with edge of track.
Ends of bottom channels
should abut at center of center
track. Align holes in bottom
channels and track units and
fasten together with lag
screws.
2 x 6"
Flat
Bottom
Channel
2 x 6"
Sloped
Bottom
Channel