Hired-Hand RollSeal Sidewall System (Curtain): SideWall Curtain - Manual (Page 23)

Part No. 4801-5072 Rev 9-08 Side Wall Curtain Page 23
Drive insert
Drive pipe
Figure 28
Exploded view showing attachment
of two drive pipes to motor.
Motor
Motor mount
Motor
shaft/sprocket
assembly
8.11.4 Installation Of Drive Pipe
1. Refer to Section 8.11 for instructions on placing drive pipe into guide brackets. Refer to
section 8.10.4 after installing drive pipe.
2. Refer to Fig. 28. Insert drive shaft/sprocket assembly into center hole
of drive insert. Rotate drive shaft to align groove in shaft with two screw
in drive insert.
3. Install lock screws through holes. Tighten lock screws securely.
8.11.5 Lock Motor Attachment
1. Attach Lock motor to motor mount with four bolts provided. Tighten bolts securely.
2. After attaching Lock motor to motor mount, make sure that sprockets are in line and
separated by 5/8" (1.58 cm). If necessary, loosen two screws holding insert & drive
shaft. Slide drive shaft to achieve proper spacing between sprockets. Tighten set screws
securely.
3. Connect sprockets together with double link chain.
5/8" (1.58 cm)
Figure 29
Wrap double link chain
around sprockets.
Connect end links together.