Brocade MLX Series and NetIron Family (Supporting Multi-Service IronWare R05.6.xx) - Manual (Page 61)

Brocade MLX Series and NetIron Family Documentation Updates 53
53-1003301-07
PBIF Recovery
4
PBIF Recovery
In the event PBIF gets locked up, PBIF recovery is activated by default with the option to activate
PBIF recovery through the command
[no] system-monitoring pbif lp-reset-recovery
.
Syntax
system-monitoring pbif lp-reset-recovery
[no] system-monitoring pbif lp-reset-recovery
Command Default
PBIF is locked up.
Examples
In the event PBIF is locked up, PBIF recovery is activated by default. However, if necessary you may
activate PBIF recovery through the
system-monitoring pbif lp-reset-recovery
command.
Brocade# config
Brocade(config)# system-monitoring pbif lp-reset-recovery
Brocade(config)# exit
Brocade# write memory
Brocade# reload
To deactivate PBIF recovery perform the
no system-monitoring pbif lp-reset-recovery
command.
Brocade# config
Brocade(config)# no system-monitoring pbif lp-reset-recovery
Brocade(config)# exit
Brocade# write memory
Brocade# reload
Router modules
NOTE
Starting with the 5.6.00a code release, XMR-32, MLX-32, and MLXe-32 systems will support a
maximum of 25 NI-MLX-1GX48-T-A modules. If more than 25 NI-MLX-1GX48-T-A modules are
currently installed in these systems and the code is upgraded to any NetIron patch or software
release later than 5.6.00 from a pre-5.6.00 NetIron release, the system will no longer recognize the
remaining NI-MLX-1GX48-T-A modules. It is recommended that these excess modules are removed
from the system and all references to these slots are removed from the startup configuration prior
to upgrading to any 5.6.00 patch release.