Brocade MLX Series and NetIron Family (Supporting Multi-Service IronWare R05.6.xx) - Manual (Page 18)

10 Brocade MLX Series and NetIron Family Documentation Updates
53-1003301-07
Running configuration sequence number display
1
Running configuration sequence number display
The sequence number display on running configuration has been updated to display as the
following example.
Example of show run
stub-cat-201(config-mac-acl-in-sample)#show run
sequence 10 permit 0000.0291.1502 ffff.ffff.ffff any 545 etype any
sequence 20 permit 0000.2222.2222 ffff.ffff.ffff any 1201 etype any <-Newly added
ACL rule with sequence number
sequence 30 permit 0000.0201.1502 ffff.ffff.ffff any 401 etype any
Example of show access-list l2 command
stub-cat-201(config-mac-acl-in-sample)#show access-list l2 in-sample
L2 MAC Access List in-sample : 3 entries
sequence 10 permit 0000.0291.1502 ffff.ffff.ffff any 545 etype any
sequence 20 permit 0000.2222.2222 ffff.ffff.ffff any 1201 etype any <-Newly added
ACL rule with sequence number
sequence 30 permit 0000.0201.1502 ffff.ffff.ffff any 401 etype any
DVMRP legacy protocol support
Multi-Service IronWare does not support DVMRP. Use PIM as an alternative protocol for multicast.
LAG formation rules
The LAG formation rules listed below must be followed.
• You cannot configure a port concurrently as a member of a static, dynamic, or keep-alive LAG.
• Any number or combination of ports between 1 and 32 within the same chassis can be used to
configure a LAG. The maximum number of LAG ports is checked when adding ports to a LAG.
• All ports configured in a LAG must be of equal bandwidth. For example all 10 G ports.
• All ports configured in a LAG must be configured with the same port attributes.
• LAG formation rules are checked when a static or dynamic LAG is deployed.
• A LAG must have its primary port selected before it can be deployed.
• All ports configured in a LAG must be configured in the same VLAN.