Brocade MLX Series and NetIron Family (Supporting Multi-Service IronWare R05.6.xx) - Manual (Page 48)

40 Brocade MLX Series and NetIron Family Documentation Updates
53-1003301-07
IPv4 ACL-based rate limiting updates
1
IPv4 ACL-based rate limiting updates
The following updates are made in Traffic Management Guide under Configuration considerations
and Configuring a port-and-ACL-based traffic policing policy sections of the “Configuring Traffic
Policing for the Brocade NetIron CES and Brocade NetIron CER” chapter.
Configuration considerations
• IPv4 ACL-based rate limiting is not supported on VPLS and VLL endpoints.
• IPv4 ACL-based rate limiting on a port that belongs to a VLAN is not supported on a VLAN
without a VE configured.
• IPv4 ACL-based rate limiting is not supported on a port that belongs to a VLAN where in Layer 3
Interface (VE) is configured for MPLS.
Configuring a port-and-ACL-based traffic policing policy
• IPv4 ACL-based rate limiting is not supported on VPLS and VLL endpoints.
• IPv4 ACL-based rate limiting on a port that belongs to a VLAN is not supported on a VLAN
without a VE configured.
• IPv4 ACL-based rate limiting is not supported on a port that belongs to a VLAN where in Layer3
Interface (Ve) is configured for MPLS.
How the Brocade device processes ACLs
The following updates are made in the Security Guide under How the Brocade device processes
ACLs, General configuration guidelines section of the “Access Control List” chapter.
General configuration guidelines
• IPv4 ACL-based rate limiting on a port that belongs to a VLAN is not supported on a VLAN
without a VE configured.
• IPv4 ACL-based rate limiting is not supported on a port that belongs to a VLAN where in Layer 3
Interface (Ve) is configured for MPLS.