Fe access recovery disable, Usage guidelines, Output – Brocade MLX Series and NetIron Family (Supporting Multi-Service IronWare R05.6.xx) User Manual

Page 49

Brocade MLX Series and NetIron Family Documentation Updates

53-1003301-07

FE access recovery disable

To disable a RAS feature that will power-cycle a switch fabric module if SW cannot access fabric
element.

Syntax: system-init fe-access-recovery-disable

Usage Guidelines

The system does the periodic monitoring of FE access and keeps a log for this by code monitoring
fabric links and kicks off when number of links down exceeds defined threshold for traffic. However
if failure detection configuration is enabled, you need to use these commands for recovery.

Output

The ~ system-init ~ command configures the following information:

Examples:

Brocade(config)#system-init fe-access-recovery-disable

Brocade(config)#no system-init fe-access-recovery-disable

Brocade(config)#

TABLE 7

Command

Description

block-g1-sfm

Configure the system to block g1 switch fabric module.

fabric-data-mode

Configure the fabric data mode.

fabric-failure-detection

Configure the system to automatically detect and shutdown failure
fabric

fe-access-recovery-disable Configure fabric element access failure recovery disable.
max-tm-queues

Configure maximum number queues in traffic manager to 4.

mlxe32-24x10g-enable

Configure the system to accept 24x10G module.

tm-credit-size

Configure traffic manager credit size.