Brocade MLX Series and NetIron Family (Supporting Multi-Service IronWare R05.6.xx) - Manual (Page 52)

44 Brocade MLX Series and NetIron Family Documentation Updates
53-1003301-07
Configuring and enabling sFlow
1
Configuring and enabling sFlow
The following note is removed from the Configuring and enabling sFlow section in the sFlow chapter
of the Brocade MultiService IronWare Switching Configuration Guide.
NOTE
If you change the router ID or other IP address value that sFlow uses for its agent_address, you must
disable and then re-enable sFlow to use the new source address.
Multicast queue size, flow control, rate shaping and egress buffer
threshold
NOTE
The following section is applicable for the NetIron 5600 Traffic Management Guide under the
section titled Multicast queue size, flow control, rate shaping and egress buffer threshold.
The following commands are only applicable for the Brocade MLX Series platform. These
commands are not operable on the Brocade NetIron CER or Brocade NetIron CES platforms.
qos multicast-queue-type queue-number max-queue-size queue-size
qos multicast flow-control
qos multicast shaper [guaranteed | best-effort ] rate bandwidth
qos multicast egress-max-buffer port { [guaranteed_max_buffer]
[best-effort_max_buffer] }
qos multicast egress-max-buffer port {
[guaranteed_max_buffer][best-effort_max_buffer] }
Enabling PVST+ support
NOTE
The following changes are made to the Enabling PVST+ support section in the Configuring Spanning
Tree Protocol chapter of the Brocade MultiService IronWare Switching Configuration Guide.
Existing content:
If you want a tagged port to also support IEEE 802.1Q BPDUs, you need to enable the dual-mode
feature on the port. The dual-mode feature is disabled by default and must be enabled manually.
Modified content:
The tagged port also supports IEEE 802.1Q BPDUs, since the dual-mode feature on the port is
enabled, by default.