Brocade MLX Series and NetIron Family (Supporting Multi-Service IronWare R05.6.xx) - Manual (Page 29)

Brocade MLX Series and NetIron Family Documentation Updates 21
53-1003301-07
Modify OSPF standard compliance setting
1
Hardware is GigabitEthernet, address is 001b.eda3.f841 (bia 001b.eda3.f841)
Configured speed auto, actual 1Gbit, configured duplex fdx, actual fdx
Member of 1 L2 VLAN(S) (tagged), port is in tagged mode, port state is
Forwarding
STP configured to ON, Priority is level0, flow control enabled
Priority force disabled, Drop precedence level 0, Drop precedence force
disabled
dhcp-snooping-trust configured to OFF
mirror disabled, monitor disabled
LACP BPDU Forwarding:Disabled
LLDP BPDU Forwarding:Disabled
L2L3 protocols Forwarding:Enabled
Not member of any active trunks
The forward-all-protocol command forwards the following protocols by hardware instead of the CPU.
For L2: UDLD (drop), FDP, CDP and MRP.
For L3: IP broadcast (255.255.255.255), IP multicast ((224.0.0.x, 224.0.1.x) including RIP, OSPF,
PIM, VRRP), ARP, DHCP, BOOTP, IS-IS, OSPF, ND6, RIPng, OSPFv3, PIMv6, anycast solicited node,
DHCPv6.
This command cannot be used on an MPLS interface as it will break existing neighbor relationship.
Modify OSPF standard compliance setting
The following note is added to the “Configuring OSPF Version 2” chapter of the Multi-Service
IronWare Routing Configuration Guide under the “Modify OSPF standard compliance setting”
section.
NOTE
In the current implementation, the NetIron devices are not compliant with RFC3509.
VRRP and VRRP-E
The feature support table for VRRP and VRRP-E chapter is updated with the following changes.
VRRP v3 for IPv4,IPv6 and VRRP-E v6,VRRP alongside OSPF and VRRP alongside BGP4 features
are not supported across the Brocade NetIron CES 2000 Series BASE package.