Cable specifications, Power cords, Cable specifications power cords – Brocade ICX 6450 Stackable Switches Hardware Installation Guide User Manual
Page 97
Console serial RJ45 management port pinouts
TABLE 23
Pin number
Definition
Notes
1
NC
2
NC
3
UART0_TX
Console Port
4
GND
5
GND
6
UART0_RX
Console Port
7
NC
8
NC
Cable specifications
For information about supported transceivers and cable lengths and types, refer to the following
Brocade website at:
NOTE
Cable installation and network configuration affects overall transmission capability. For network-specific
recommendations, consult your local Brocade reseller or system engineer.
Power cords
NOTE
Brocade recommends that you use the power cord that is shipped with the device.
For the ICX 6430 and ICX 6450 devices to operate at 100V, the power cord should be C13 type
connector with 13A rating or better (NEMA-5-15 plug)
For the ICX 6430 and ICX 6450 devices to operate at 240V, the power cord should be C13 type
connector with 10A rating or better.
For the ICX 6400-EPS1500 to operate at 100V, the power cord should be C19 type connector with 20A
rating or better (NEMA5-20P plug)
For the ICX 6400-EPS1500 to operate at 240V, the power cord should be C19 type connector with 13A
or better.
All devices ship with United States compatible power cords unless otherwise specified at the time of
order. United Kingdom- and European-compatible power cords are also available.
Cable specifications
Brocade ICX 6430 and ICX 6450 Stackable Switches Hardware Installation Guide
95
53-1003079-01