Brocade ICX 6450 Stackable Switches Hardware Installation Guide - Manual (Page 19)

Specifying a stacking port
The port address format is stack unit/slot/port , where:
• stack unit --Specifies the stack unit ID. For the ICX 6430, range is from 1 to 4. For the ICX 6450,
range is from 1 to 8.
• slot --Specifies the slot number. Stacking ports are in slot 2.
• port --Specifies the port number in the slot. Stacking ports are 1, 2, 3, and 4.
This example shows how to specify stacking port 3 in slot 2 of unit 3 in a stack:
Brocade (config) # interface ethernet 3/2/3
Specifying a management port
The management port number is always 1. This example shows how to specify the management port:
Brocade (config) # interface management 1
Port, system, and power status LEDs
ICX 6430 and ICX 6450 devices include LEDs that indicate the status of device components.
1 Port status LEDs
FIGURE 15 Port status LEDs on 24-port models
1 Port status LEDs
2 Port status LEDs
FIGURE 16 Port status LEDs on 48-port models
Specifying a stacking port
Brocade ICX 6430 and ICX 6450 Stackable Switches Hardware Installation Guide 17
53-1003079-01