Brocade ICX 6450 Stackable Switches Hardware Installation Guide User Manual
Page 30
NOTE
You need a #2 Phillips screwdriver for rack mount installation.
Complete the following steps to mount devices in rack.
1.
Remove the rack mount kit from the shipping carton. The kit contains two L-shaped mounting
brackets and six sink-head screws.
2.
Using a Phillips screwdriver, attach the mounting brackets to the sides of the device using six
sink-head screws.
FIGURE 22 Attaching the mounting brackets for ICX 6430 and ICX 6450 devices
3.
Remove the two-post rack kit from the shipping carton. The kit contains four rack-mounting
screws and four cage nuts.
4.
Insert the cage nuts in the two-post rack where you want to mount the device.
5.
Using a Phillips screwdriver, mount the device in a two-post rack using four rack-mounting
screws.
NOTE
The ICX 6430 and ICX 6450 devices must be installed on 2-post racks only. The devices cannot
be installed on 4-post racks.
ICX 6430 and ICX 6450 Installation
28
Brocade ICX 6430 and ICX 6450 Stackable Switches Hardware Installation Guide
53-1003079-01