Brocade ICX 6450 Stackable Switches Hardware Installation Guide - Manual (Page 100)

In-band access
You can access the management agent in the device from anywhere within the attached network
using Telnet, or other network management software. However, you must first configure the device
with a valid IP address, subnet mask, and default gateway. If you have trouble establishing a link to
the management agent, check to see if you have a valid network connection. Then verify that you
entered the correct IP address. Also, be sure the port through which you are connecting to the device
has not been disabled. If it has not been disabled, then check the network cabling that runs between
your remote location and the device.
In-band access
98 Brocade ICX 6430 and ICX 6450 Stackable Switches Hardware Installation Guide
53-1003079-01