Brocade ICX 6450 Stackable Switches Hardware Installation Guide - Manual (Page 17)

Out-of-band management interface
The out-of-band management interface is an RJ45 port that allows you to configure and manage the
device from the network.
System reset button
The reset button allows you to restart the system without switching the power supply off and on, using
the CLI. When the reset button is pressed, the system resets and the software is reloaded. The button
is located to the left of the console management interface.
Network interfaces for ICX 6430 and ICX 6450 devices
ICX 6430 and ICX 6450 devices contain the following interfaces:
• 10/100/1000 Mbps ports with RJ45 copper connectors.
• SFP/SFP+ ports.
SFP ports support 1 Gbps port speeds. SFP+ ports support 10 Gbps port speeds.
NOTE
ICX 6430 models support SFP ports only. ICX 6450 models support both SFP or SFP+ ports.
Slot designations
Refer to Network and management interfaces on page 14 for the location of slot 1 and slot 2 on the
front panel of the 24-port models and the 48-port models.
Slot designations for ICX 6430 and ICX 6450 devices TABLE 1
Device Slot 1 (10/100/1000 BASE-T ports) Slot 2 (SFP and SFP +ports)
ICX 6430-24 10/100/1000 Mbps ports 1-24 SFP ports 1-4
ICX 6430-24P 10/100/1000 Mbps ports 1-24 SFP ports 1-4
ICX 6430-48 10/100/1000 Mbps ports 1-48 SFP ports 1-4
ICX 6430-48P 10/100/1000 Mbps ports 1-48 SFP ports 1-4
ICX 6450-24 10/100/1000 Mbps ports 1-24 SFP and SFP+ ports 1-4
ICX 6450-24P 10/100/1000 Mbps ports 1-24 SFP and SFP+ ports 1-4
ICX 6450-48 10/100/1000 Mbps ports 1-48 SFP and SFP+ ports 1-4
ICX 6450_48P 10/100/1000 Mbps ports 1-48 SFP and SFP+ ports 1-4
Out-of-band management interface
Brocade ICX 6430 and ICX 6450 Stackable Switches Hardware Installation Guide 15
53-1003079-01