Installing the device, Desktop installation – Brocade ICX 6450 Stackable Switches Hardware Installation Guide User Manual
Page 56
•
Temperature: Because the temperature within a rack assembly may be higher than the ambient
room temperature, check that the rack-environment temperature is within the specified operating
temperature range.
•
Mechanical loading: Do not place any equipment on top of a rack-mounted device.
•
Circuit overloading: Be sure that the supply circuit to the rack assembly is not overloaded.
•
Grounding: Rack-mounted equipment should be properly grounded.
Installing the device
You can install the device on a desktop or in an equipment rack.
DANGER
Mount the devices you install in a rack or cabinet as low as possible. Place the heaviest device
at the bottom and progressively place lighter devices above.
Desktop installation
Complete the following steps to install the ICX 6400-EPS1500 on a desktop or other flat surface.
1.
Attach the four adhesive feet to the bottom of the external power supply. Refer to
on page 54.
FIGURE 43 Attaching the adhesive feet to the ICX 6400-EPS1500
2.
Set the external power supply on a flat surface near an AC power source, making sure there are
at least 5.08 cm (2 in.) of space on all sides for proper airflow.
Installing the device
54
Brocade ICX 6430 and ICX 6450 Stackable Switches Hardware Installation Guide
53-1003079-01