Yokogawa Standalone MW100 - Manual (Page 26)

IM MW100-0E
Starting Recording
1. Check whether the instrument is measuring by looking at the MW100 main
module’s status indicator, or in the browser’s top screen.
. Press the MW100 main module’s START key for about two seconds, or select
Start in the Operation list under Recording in the browser top screen’s Status
table.
Measured data is saved to the CF card.
File menus are automatically generated using the date and serial number.
MDDIXXXX.MXD
M: Month file created (local time), 1 to 9, X (October), Y (November), Z (December)
DD: Date when file created (local time), 1 to 31
I: Files in measurement groups 1 to 3 are 1 to 3
Computed data file is M
Thinned values, T
XXXX: Sequence number 0000 to 9999
MXD: MW100 file extension (uppercase)
Stopping Recording
1. Check whether the instrument is measuring or recording by looking at the MW100
main module’s status indicator, or the browser’s top screen.
. Press the MW100 main module’s STOP key for about two seconds, or select Stop
in the Operation list under Recording in the browser top screen’s Status table.
Recording stops.
Stopping Measurement
1. Check whether the instrument is measuring or stopping recording by looking at
the MW100 main module’s status indicator, or the browser’s top screen.
. Briefly press the MW100 main module’s STOP key, or select Stop in the Operation
list under Measurement in the browser top screen’s Status table.
Measurement stops.
Note
This document does not cover MATH settings, or how to start and stop computation. Please
refer to the MW100 Data Acquisition Unit user’s manual (IM MW100-01E).
The process is described in the status transition diagram.
Setting
Recording
Measurement
MATH*
Press and hold
for 2 seconds.
Press and hold
for 2 seconds.
Press and hold
for 2 seconds.
Press and hold
for 2 seconds.
* On models with the /M1
option, or when the 10-CH
Pulse Input Module is
installed
Starting and Stopping Measurement and Recording