Programming program menu program menu – Watlow Series 922 User Manual
Page 60
WATLOW Series 922 User's Manual
60
How To Program the Series 922, Chapter 6
Programming
PROGRAM Menu
PROGRAM Menu
SETPOINT step is executed. These events only appear when the 8
output event board is connected to the Series 922.
Range: OFF or ON
Default: Unprogrammed
OFF = Event OFF
ON = Event ON
From RETURN, you can go back to the SYSTEM prompt by pressing
the ENTER key, or return to FILE? by pressing the MODE key.
One of six step types under the PROGRAM menu of the Series 922
that can be programmed as a step or file. You can jump from one
step to another within a file.
The Series 922 will jump loop to any step within your current file. You
cannot jump loop to another step in another file.
Range: 1 to 99
Default: 1
The number of times that the Series 922 jumps to the step that was
specified by the JS step. 0 = Infinite number of jumps.
Range: 0 to 100
Default: 0
From RETURN, you can go back to the SYSTEM prompt by pressing
the ENTER key, or return to FILE? by pressing the MODE key.
One of six step types under the PROGRAM menu of the Series 922
that can be programmed to wait for a specific amount of time, a
desired set point or both. When either or both are used, they must be
true before the program continues.
Value the system compares against the process variable of Channel
1, and waits for, before proceeding to the next step of the program.
Range: R1L to R1H
Default: Unprogrammed
Value the system compares against the process variable of Channel
2, and waits for, before proceeding to the next step of the program.
This parameter will not appear if "T" or "P" (Channel 1 only) in the
TYP parameter under the SPCLFUNC menu have been selected.
Range: R2L to R2H
Default: Unprogrammed
The hours the system will wait for, relative to when the step began.
This is not a measure of time-of-day.
Range: 0 to 23 hours
Default: Unprogrammed
Represents the minutes the system will wait for, relative to when the
step began. This is not a measure of time-of-day.
Range: 0 to 59 minutes
Default: Unprogrammed
W2 ( )
EV3 ( )
EV4 ( )
EV5 ( )
EV6 ( )
EV7 ( )
EV8 ( )
RETURN
JUMPLOOP
JS ( )
JC ( )
RETURN
WAITFOR
W1 ( )
WHR ( )
WMN ( )