Watlow Series 922 - Manual (Page 59)

How To Program the Series 922, Chapter 6 WATLOW Series 922 User's Manual
59
PROGRAM Menu
SEC ( )
MIN ( )
HOUR ( )
One of three main level operating menus. From the SETUP menu,
you can enter or view step type, program loops, wait for conditions,
set points, auxiliary (event) outputs ON/OFF, and step duration.
Represents the current SYSTEM file of the Series 922 to be edited or
reviewed.
Range: 1 to 10 files
Default: 1
Represents the current step of a file of the Series 922 to be edited or
reviewed.
Range: 1 to 99 steps
Default: 1
One of six step types under the PROGRAM menu of the Series 922.
Can be programmed as a file or a step to achieve or maintain a set
point.
Represents the temperature that the system will try to achieve on
Channel 1 in the amount of time given. This will be done linearly,
producing a ramp from a beginning set point to an end set point.
Range: R1L to R1H
Default: Unprogrammed
Represents the temperature that the system will try to achieve on
Channel 2 in the amount of time given. This will be done linearly,
producing a ramp from a beginning set point to an end set point. This
parameter will not appear if the TYP prompt under the SPCLFUNC
menu has been selected as "T" (Temperature for Channel 1 only) or
"P" (Process for Channel 1 only).
Range: R2L to R2H
Default: Unprogrammed
The number of hours, in combination with the MIN and SEC
parameters, that equal the total step time to achieve the temperature
under the SETPOINT step-type.
Range: 0 to 23 hours
Default: Unprogrammed
The number of minutes that equal total step time to achieve the
temperature of the Series 922. Under the SETPOINT step-type.
Range: 0 to 59 minutes
Default: Unprogrammed
The number of seconds that equal total step time to achieve the
temperature of the Series 922 under the SETPOINT step-type.
Range: 0 to 59 seconds
Default: Unprogrammed
This auxiliary output can be an alarm or event. EV1 will only appear
when AUX1 = EV, and the external event board is connected to the
Series 922. Auxiliary outputs can be alarms or events.
Range: OFF or ON
Default: Unprogrammed
OFF = Event OFF ON = Event ON
EV2 can be an alarm or event. EV2 will only appear when AUX2 =
EV, and the external event board is connected to the Series 922, or
EV2 will appear if T or P in the TYP parameter under the SPCLFUNC
menu have been selected and an external event board is present.
Range: OFF or ON
Default: Unprogrammed
OFF = Event OFF ON = Event ON
Represents the state the 6 event outputs are forced to when the
SP1 ( )
SETPOINT
STEP ( )
F ILE? ( )
Program
Shaded parameters may not appear on your control. They are
dependent on your control configuration.
SP2 ( )
EV1 ( )
EV2 ( )