Watlow Series 922 - Manual (Page 42)

42
WATLOW Series 922 User's Manual How To Program the Series 922, Chapter 6
After selecting a value with the keys, press .
Continue to the next parameter by pressing .
Press to enter SYSTEM menu.
M
E
SP2
EV1
EV2
ER1
ER2
RETURN
SYSTEM
CLR ALARM
To SYSTEM
SP1
C2
EV3
EV4
EV5
EV6
EV7
EV8
( )
( )
( )
( )
( )
( )
( )
( )
( )
( )
( )
( )
EI
Figure 31 -
SYSTEM Key Flow
At any RETURN, you can press to return to
SYSTEM,
or press to return to the first parameter. M
E
SYSTEM Menu
The next pages will show you each of the Series 922 menus and their prompts and
values. Each section, SYSTEM, SETUP, and PROGRAM, has a menu graphic
with a table of values, followed by prompt definitions. Don't write in the tables and
charts here, but make copies to document your control.
Prompt definitions are also listed in the glossary.
Programming in General
Programming the Series 922 is easy as 1 - 2 - 3:
1. Use the MODE key to select the alphanumeric display prompt you want.
2. Use the UP/DOWN keys to select data or prompts in the alphanumeric display.
3. Press ENTER.
SYSTEM Menu
The SYSTEM mode has the capability to generate a non-ramping set point and
manipulate events. You can also clear alarms and error codes from this menu.
Step through the SYSTEM menu using the key flow diagram and table below.
M
E
Graphics Key
= MODE Key
= ENTER Key
= UP/DOWN Key
E
M
C2/RH
NOTE: Shaded
parameters may not
appear on your
control. These
parameters are
dependent on how
your control is
configured. See
Pages 43 - 44 for
more information.