Watlow ANASCAN - Manual (Page 45)

SYSTEM SETUP
ANASCAN User’s Guide 37
new process or for a short time, when the process is first started,
you may set automatic switching to Off. The large alarm block will
still indicate by flashing each new alarm, but the system will not
automatically switch to the alarm screen.
• Audible Alarm. Set to On or OFF. When on, the computer emits an
audible warning for each new alarm.
System Terminate
• This window allows you to terminate ANASCAN.
• Press Enter when the cursor is on the “Terminate Program” mes-
sage. The program prompts as follows:
Terminate Program (Y/N)?
If you have edited the current job without saving to disk, the following
message appears:
NOTE: The current job has been changed. To save changes to job file,
use the Save Job function of the Job Setup screen before terminating the
program.
• The program terminates and returns to the operating system.
• If you terminate the program only for a short time, to change a disk
or to fix a computer problem, and safety devices are in the process,
you can leave the CAS On.