Ramsey Winch H-89 - Manual (Page 15)

15
FIGURE 4
Remove motor #85 from adapter plate #29 by
removing capscrews #59. Remove adapter
plate and coupling #3 from adapter #6 by
unscrewing eight capscrews #56.
Remove key #26 from worm shaft. Unscrew
six capscrews #58 and remove adapter from
gear housing. Replace adapter seal #94 and
gasket #78.
Drag brake #17, spacer #103 and springs #98 should be
examined and replaced if necessary.
FIGURE 5
Remove brake housing #20 from gear housing
by unscrewing six #57 capscrews. Refer to
page 7, SERVICING OIL COOLED HOLDING BRAKE.
Remove key #25 from worm. Remove worm
#36 and bearings #40 from gear housing. Use
a soft hammer to gently tap input end of worm, driving
worm and bearing from gear housing. Once worm has been
removed from housing, bearing can be pressed from end of
worm. Check for signs of wear or damage to worm #36
and bearings #40. Replace if necessary.
FIGURE 6
Remove gear-housing cover #16 from gear
housing #22 by unscrewing eight capscrews
#47. Thread two of the capscrews into the two
tapped holes of cover and tighten. This will pull
the cover loose from gear housing. Remove cover gasket
#80 and pull shaft #32, with gear #19 and spacer #101
attached, from gear housing.
FIGURE 7
If necessary, replace gear. Check lube fittings #84 and
reducer #87 for damage and replace if necessary.
87
87
84
84
32
70 19
52
24
FIGURE 7
19
80
32
22
101
47
16
FIGURE 6