Ramsey Winch RPH-8000 User Manual

Page 9

INSTRUCTIONS FOR OVERHAUL RPH-8000 SERIES WINCH

Take note of mounting configurations for proper mounting of parts during re-assembly. Replace all gaskets, o-rings,
and seals during re-assembly.

Remove breather plug and reducer (item #34 and #39) from
winch. Drain oil from winch by removing plug (item #40).
Remove motor (item #35), coupling (item #31) from winch
by unscrewing capscrews (item #24). If coupling is being
replaced, be sure pin (item #41) is installed. Tap motor lightly
to disengage. Replace all o-rings and seals with new ones
during re-assembly (order kit #246042). If necessary, remove
valve (item #49) from motor by removing lockwashers (item
#52) and capscrews (item #21).

Remove tie plates (item #13) from end bearings (items #7 &
#8) by unscrewing capscrews (item #18), as shown. Slide
motor end bearing (item #7) from drum (item #1) and drum
from gear housing end bearing (item #8). Remove input shaft
(item #12) from end bearing. Inspect teeth of gear (item #5)
for signs of wear. If necessary replace gear by removing snap
ring (item #47) and thrust washer (item #50). Slide new
gear over splines of shaft and against snap ring on shaft. Re-
install thrust washer and place snap ring into groove of shaft.

50 47