5 removing the back cover, Emoving the, Over – IEI Integration AFL-08AH-N270 User Manual

Page 38: Figure 4-1: back cover retention screws

AFL-08AH-N270-CR Panel PC

Page 24

4.5 Removing the Back Cover

WARNING:

Do not modify this equipment without authorization of the

manufacturer.

Only certified engineers should install and modify the hardware

settings

. Incorrect settings can cause irreparable damage to the

system.

WARNING:

Over-tightening back cover screws will crack the plastic frame.

Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).

To access the AFL-08AH-N270-CR internally the back cover must be removed. To remove

the back cover, please follow the steps below.

Step 1:

Remove the retention screws (Figure 4-1) and lift the cover off the flat panel PC.

Figure 4-1: Back Cover Retention Screws

Step 2:

Lift the back cover off the system.