IEI Integration ECN-360A-D2550 - Manual (Page 28)

ECN-360A-D2550 Em b e d d e d S ys te m
P a g e 17
S te p 5: Align the mounting holes in the sides of the mounting brackets with the predrilled
holes in the mounting surface.
NOTE:
To have the best system heat dissipation, please make sure to face the
I/O panel downward (Figure 3-5) when mounting the system.
S te p 6: Insert four retention screws, two in each bracket, to secure the system to the
wall. S te p 0:
3.6 Exte rn a l P e rip h e ra l In te rfa c e Co n n e c to rs
The following external peripheral devices can be connected to the external peripheral
interface connectors.
 Audio devices
 RJ-45 Ethernet cable
 Serial devices
 USB devices
 VGA monitor
To install these devices, connect the corresponding cable connector from the actual
device to the corresponding ECN-360A-D2550 external peripheral interface connector
making sure the pins are properly aligned.
3.6.1 Au d io Co n n e c tio n
The audio jack on the external audio connector enables the ECN-360A-D2550 to be
connected to a stereo sound setup. To install the audio devices, follow the steps below.
S te p 1: Identify the audio plugs. The plugs on your home theater system or speakers
may not match the colors on the rear panel. If audio plugs are plugged into the
wrong jacks, sound quality will be very bad.