1 acc on, 1 boot-up, Figure 3-35: acc on: at mode – IEI Integration TANK-700-QM67 v2.00 User Manual

Page 54: Figure 3-36: acc on: atx mode

TANK-700 Em b e d d e d S ys te m

P a g e 42

3.11.1 ACC ON

NOTE:

In ACC On mode, the Power 1 connector must connect to the ACC on

signal to be able to control system power.

The ACC On mode is designed for vehicle applications. When the TANK-700 is in ACC

On mode, the main power input is the Power 1 connector and the backup power is from

the Power 2 connector.

3.11.1.1 Bo o t-u p

When both power connectors are connected to a power source with over 9 V, the two

power LEDs on the front panel remain off until the ACC ON signal jumps from low to

high. The user can choose AT power mode or ATX power mode to control the system.

The following flow diagrams show the boot-up process and the LED status in AT and ATX

power modes.

Figure 3-35: ACC On: AT Mode

Figure 3-36: ACC On: ATX Mode