IEI Integration TANK-700-QM67 v2.00 - Manual (Page 35)

TANK-700 Em b e d d e d S ys te m
P a g e 23
S te p 5: Push the SO-DIMM into the socket at an angle (Figure 3-10).
Figure 3-10: SO-DIMM Installation
S te p 6: Gently pull the arms of the SO-DIMM socket out and push the rear of the
SO-DIMM down (Figure 3-10).
S te p 7: Release the arms on the SO-DIMM socket. They clip into place and secure the
SO-DIMM in the socket.
S te p 8: Install the bracket that was previously removed in the same position it was
before.
S te p 9: Reinstall the bottom panel to the TANK-700.
3.8 Mo u n tin g th e S ys te m with Mo u n tin g Bra c ke ts
To mount the embedded system onto a wall or some other surface using the two mounting
brackets, please follow the steps below.
S te p 1: Turn the embedded system over.
S te p 2: Align the two retention screw holes in each bracket with the corresponding
retention screw holes on the sides of the bottom surface (Figure 3-11).