IEI Integration TANK-700-QM67 v2.00 - Manual (Page 32)

TANK-700 Em b e d d e d S ys te m
P a g e 20
S te p 2: Align the pluggable DC-in terminal block with the DC-in terminal block connector
on the TANK-700.
S te p 3: Once aligned, insert the pluggable DC-in terminal block into the DC-in terminal
block connector.
S te p 4: Secure the pluggable DC-in terminal block to the external interface by tightening
the two retention screws on either side of the terminal block (Figure 3-6).
Figure 3-6: Pluggable DC-in Terminal Block Installation
3.5 P lu g g a b le Re m o te Co n tro l Te rm in a l Blo c k In s ta lla tio n
To install the pluggable remote control terminal block, please follow the steps below:
S te p 1: Locate the remote control terminal block connector. The location of the
connector is shown in Figure 1-3.
S te p 2: Align the pluggable remote control terminal block with the remote control
terminal block connector on the TANK-700.
S te p 3: Once aligned, insert the pluggable remote control terminal block into the remote
control terminal block connector.
S te p 4: Secure the pluggable remote control terminal block to the external interface by
tightening the two retention screws on either side of the terminal block
(Figure 3-7).