4 jumper settings, 1 clear cmos jumper, Umper – IEI Integration KINO-9652 v1.00 User Manual
Page 102: Ettings, Figure 5-7: jumper locations, Table 5-1: jumpers
KINO-9652 Mini-ITX SBC
Page 80
5.4 Jumper Settings
NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three metal
pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect
them. To CLOSE/SHORT a jumper means
connecting the pins of the jumper with the plastic
clip and to OPEN a jumper means removing the
plastic clip from a jumper.
Figure 5-7: Jumper Locations
Before the KINO-9652 is installed in the system, the jumpers must be set in accordance
with the desired configuration. The jumpers on the KINO-9652 are listed in Table 5-1.
Description
Label
Type
Clear CMOS
J_CMOS1
3-pin header
COM 4 function selection
JP5
6-pn header
COM port RI and voltage selection
JP1, JP2
10-pin header
LVDS LCD voltage selection
J_VLVDS1
3-pin header
LVDS LCD resolution selection
JP3
8-pin header
Table 5-1: Jumpers
5.4.1 Clear CMOS Jumper
Jumper Label:
J_COMS1
Jumper Type:
3-pin header
Jumper Settings: