Vanguard EZCT-2000C Plus - Manual (Page 76)

EZCT-2000C USER’S MANUAL REV 1
72
3.5.4. Printing a Test Plan
To print a test plan:
a. Start from the “START-UP” menu:
Press the
[3]
key (TEST PLANS).
b. The following screen will be displayed:
Press the [5] key (PRINT TEST PLAN).
c. The following screen will be displayed:
Type the test plan number that you would like to print and press the [ENTER] key. If
you do not know the test plan number, you can first print the test plan directory using
the instructions in section 3.5.2.
The test plan will be printed on the thermal printer and you will be returned to the
“START-UP” menu. A typical test plan printout is shown in Figure 22. Test plan elements
are described in Table 5.
PRINT TEST PLAN
NUMBER:
1. load test plan
2. unload test plan
3. plan directory
4. extract test plan
5. print test plan
6. erase test plan
7. copy to thumb drive
1. RUN TEST 04/19/13
2. SETUP 10:14:25
3. TEST PLANS
4. DIAGNOSTICS
5. CURRENT SOURCE