Vanguard EZCT-2000C Plus - Manual (Page 74)

EZCT-2000C USER’S MANUAL REV 1
70
3.5.3. Printing a Directory of Test Plans Stored in a USB Flash Drive
To print a directory of all the test plans stored in a USB Flash drive:
a. Make sure the USB Flash drive is inserted in the EZCT-2000C’s USB Flash drive port
(“USB MEM” port). Then start from the “START-UP” menu:
Press the
[3]
key (TEST PLANS).
b. The following screen will be displayed:
Press the
[3]
key (PLAN DIRECTORY).
c. The following screen will be displayed:
Press the [2] key (THUMB DRIVE DIR).
d. The following screen will be displayed while the test plan directory is being printed:
You will be returned to the “START-UP” menu once printing is finished. A typical USB
Flash drive test plan directory printout is shown in Figure 21.
PRINTING DIRECTORY
1. internal directory
2. thumb drive dir
1. load test plan
2. unload test plan
3. plan directory
4. extract test plan
5. print test plan
6. erase test plan
7. copy to thumb drive
1. RUN TEST 04/18/13
2. SETUP 14:21:29
3. TEST PLANS
4. DIAGNOSTICS
5. CURRENT SOURCE