LevelOne GTL-2690 - Manual (Page 704)

Basic IP Configuration
41-27
41
• hardware-address - The 48-bit MAC layer address for the neighbor device.
This address must be formatted as six hexadecimal pairs separated by
hyphens.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• Address Resolution Protocol (ARP) has been replaced in IPv6 with the
Neighbor Discovery Protocol (NDP). The ipv6 neighbor command is similar
to the mac-address-table static command (page 31-1) that is implemented
using ARP.
• Static entries can only be configured on an IPv6-enabled interface.
• The router does not determine whether a static entry is reachable before
placing it in the IPv6 neighbor discovery cache.
• If the specified entry was dynamically learned through the IPv6 neighbor
discovery process, and already exists in the neighbor discovery cache, it is
converted to a static entry. Static entries in the IPv6 neighbor discovery cache
are not modified if subsequently detected by the neighbor discovery process.
• Disabling IPv6 on an interface with the no ipv6 enable command (see
page 41-7) deletes all dynamically learned entries in the IPv6 neighbor
discovery cache for that interface, but does not delete static entries.
Example
The following maps a static entry for global unicast address to a MAC address:
Related Commands
show ipv6 neighbors (41-30)
mac-address-table static (31-1)
Console(config)#ipv6 neighbor 2009:DB9:2229::81 vlan 1 30-65-14-01-11-86
Console(config)#end
Console#show ipv6 neighbors
IPv6 Address Age Link-layer Addr State
Vlan
2009:DB9:2229::80 956 12-34-11-11-43-21 STALE 1
2009:DB9:2229::81 Permanent 30-65-14-01-11-86 REACH 1
FE80::1034:11FF:FE11:4321 961 12-34-11-11-43-21 STALE 1
Console#