Chapter 3: configuring the switch, Using the web interface, Configuring the switch – LevelOne GTL-2690 User Manual
Page 65

3-1
Chapter 3: Configuring the Switch
Using the Web Interface
This switch provides an embedded HTTP web agent. Using a web browser you can 
configure the switch and view statistics to monitor network activity. The web agent 
can be accessed by any computer on the network using a standard web browser 
(Internet Explorer 5.0, Netscape 6.2, Mozilla Firefox 2.0.0.0, or more recent versions).
Note:
You can also use the Command Line Interface (CLI) to manage the switch over a 
serial connection to the console port or via Telnet. For more information on using 
the CLI, refer to Chapter 21: “Overview of the Command Line Interface.”
Prior to accessing the switch from a web browser, be sure you have first performed 
the following tasks:
1. Configure the switch with a valid IP address, subnet mask, and default gateway
using an out-of-band serial connection, BOOTP or DHCP protocol. (See “Setting 
an IP Address” on page 2-7.)
2. Set user names and passwords using an out-of-band serial connection. Access
to the web agent is controlled by the same user names and passwords as the 
onboard configuration program. (See “Setting Passwords” on page 2-7.)
3. After you enter a user name and password, you will have access to the system
configuration program.
Notes: 1.
You are allowed three attempts to enter the correct password; on the third 
failed attempt the current connection is terminated.
2.
If you log into the web interface as guest (Normal Exec level), you can view 
the configuration settings or change the guest password. If you log in as 
“admin” (Privileged Exec level), you can change the settings on any page.
3.
If the path between your management station and this switch does not pass 
through any device that uses the Spanning Tree Algorithm, then you can set 
the switch port attached to your management station to fast forwarding (i.e., 
enable Admin Edge Port) to improve the switch’s response time to 
management commands issued through the web interface. See “Configuring 
Interface Settings” on page 10-13.
