LevelOne GTL-2690 - Manual (Page 559)

LLDP Commands
32-12
32
Command Usage
This option advertises the name of all VLANs to which this interface has been
assigned. See “switchport allowed vlan” on page 34-11 and “protocol-vlan
protocol-group (Configuring Interfaces)” on page 34-21.
Example
lldp dot3-tlv link-agg
This command configures an LLDP-enabled port to advertise link aggregation
capabilities. Use the no form to disable this feature.
Syntax
[no] lldp dot3-tlv link-agg
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option advertises link aggregation capabilities, aggregation status of the
link, and the 802.3 aggregated port identifier if this interface is currently a link
aggregation member.
Example
lldp dot3-tlv mac-phy
This command configures an LLDP-enabled port to advertise its MAC and physical
layer capabilities. Use the no form to disable this feature.
Syntax
[no] lldp dot3-tlv mac-phy
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot1-tlv vlan-name
Console(config-if)#
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot3-tlv link-agg
Console(config-if)#