LevelOne GTL-2690 User Manual
Levelone, Gtl-2690, Management guide
Table of contents
Document Outline
- GTL-2690
- Section I: Getting Started
- Section II: Switch Management
- Chapter 3: Configuring the Switch
- Chapter 4: Basic Management Tasks
- Displaying System Information
- Displaying Switch Hardware/Software Versions
- Displaying Bridge Extension Capabilities
- Setting the Switch’s IP Address (IP Version 4)
- Setting the Switch’s IP Address (IP Version 6)
- Configuring Support for Jumbo Frames
- Managing Firmware
- Saving or Restoring Configuration Settings
- Console Port Settings
- Telnet Settings
- Configuring Event Logging
- Renumbering the Stack
- Resetting the System
- Setting the System Clock
- Chapter 5: Simple Network Management Protocol
- Chapter 6: User Authentication
- Chapter 7: Access Control Lists
- Chapter 8: Port Configuration
- Chapter 9: Address Table Settings
- Chapter 10: Spanning Tree Algorithm
- Chapter 11: VLAN Configuration
- Chapter 12: Link Layer Discovery Protocol
- Chapter 13: Class of Service
- Chapter 14: Quality of Service
- Chapter 15: Multicast Filtering
- Chapter 16: Domain Name Service
- Chapter 17: Dynamic Host Configuration Protocol
- Chapter 18: Configuring Router Redundancy
- Chapter 19: IP Routing
- Chapter 20: Unicast Routing
- Configuring the Routing Information Protocol
- Configuring the Open Shortest Path First Protocol
- Configuring General Protocol Settings
- Configuring OSPF Areas
- Configuring Area Ranges (Route Summarization for ABRs)
- Configuring OSPF Interfaces
- Configuring Virtual Links
- Configuring Network Area Addresses
- Configuring Summary Addresses (for External AS Routes)
- Redistributing External Routes
- Configuring NSSA Settings
- Displaying Link State Database Information
- Displaying Information on Border Routers
- Displaying Information on Neighbor Routers
- Section III: Command Line Interface
- Chapter 21: Overview of the Command Line Interface
- Chapter 22: General Commands
- Chapter 23: System Management Commands
- Chapter 24: SNMP Commands
- Chapter 25: User Authentication Commands
- Chapter 26: Access Control List Commands
- Chapter 27: Interface Commands
- Chapter 28: Link Aggregation Commands
- Chapter 29: Mirror Port Commands
- Chapter 30: Rate Limit Commands
- Chapter 31: Address Table Commands
- Chapter 32: LLDP Commands
- lldp
- lldp holdtime-multiplier
- lldp notification-interval
- lldp refresh-interval
- lldp reinit-delay
- lldp tx-delay
- lldp admin-status
- lldp notification
- lldp basic-tlv management-ip-address
- lldp basic-tlv port-description
- lldp basic-tlv system-capabilities
- lldp basic-tlv system-description
- lldp basic-tlv system-name
- lldp dot1-tlv proto-ident
- lldp dot1-tlv proto-vid
- lldp dot1-tlv pvid
- lldp dot1-tlv vlan-name
- lldp dot3-tlv link-agg
- lldp dot3-tlv mac-phy
- lldp dot3-tlv max-frame
- lldp dot3-tlv poe
- show lldp config
- show lldp info local-device
- show lldp info remote-device
- show lldp info statistics
- Chapter 33: Spanning Tree Commands
- spanning-tree
- spanning-tree mode
- spanning-tree forward-time
- spanning-tree hello-time
- spanning-tree max-age
- spanning-tree priority
- spanning-tree pathcost method
- spanning-tree transmission-limit
- spanning-tree mst-configuration
- mst vlan
- mst priority
- name
- revision
- max-hops
- spanning-tree spanning-disabled
- spanning-tree cost
- spanning-tree port-priority
- spanning-tree edge-port
- spanning-tree portfast
- spanning-tree link-type
- spanning-tree mst cost
- spanning-tree mst port-priority
- spanning-tree protocol-migration
- show spanning-tree
- show spanning-tree mst configuration
- Chapter 34: VLAN Commands
- Chapter 35: Class of Service Commands
- Chapter 36: Quality of Service Commands
- Chapter 37: Multicast Filtering Commands
- Chapter 38: Domain Name Service Commands
- Chapter 39: DHCP Commands
- Chapter 40: Router Redundancy Commands
- Chapter 41: IP Interface Commands
- Basic IP Configuration
- ip address
- ip default-gateway
- show ip interface
- show ip redirects
- ping
- ipv6 enable
- ipv6 general-prefix
- show ipv6 general-prefix
- ipv6 address
- ipv6 address autoconfig
- ipv6 address eui-64
- ipv6 address link-local
- show ipv6 interface
- ipv6 default-gateway
- show ipv6 default-gateway
- ipv6 mtu
- show ipv6 mtu
- show ipv6 traffic
- clear ipv6 traffic
- ping ipv6
- ipv6 neighbor
- ipv6 nd dad attempts
- ipv6 nd ns interval
- show ipv6 neighbors
- clear ipv6 neighbors
- Address Resolution Protocol (ARP)
- Basic IP Configuration
- Chapter 42: IP Routing Commands
- Global Routing Configuration
- Routing Information Protocol (RIP)
- Open Shortest Path First (OSPF)
- router ospf
- router-id
- compatible rfc1583
- default-information originate
- timers spf
- area range
- area default-cost
- summary-address
- redistribute
- network area
- area stub
- area nssa
- area virtual-link
- ip ospf authentication
- ip ospf authentication-key
- ip ospf message-digest-key
- ip ospf cost
- ip ospf dead-interval
- ip ospf hello-interval
- ip ospf priority
- ip ospf retransmit-interval
- ip ospf transmit-delay
- show ip ospf
- show ip ospf border-routers
- show ip ospf database
- show ip ospf interface
- show ip ospf neighbor
- show ip ospf summary-address
- show ip ospf virtual-links
- Section IV: Appendices