LevelOne GTL-2690 - Manual (Page 393)

Overview of the Command Line Interface
21-8
21
To enter the other modes, at the configuration prompt type one of the following
commands. Use the exit or end command to return to the Privileged Exec mode.
For example, you can use the following commands to enter interface configuration
mode, and then return to Privileged Exec mode
Table 21-2 Configuration Command Modes
Mode Command Prompt Page
Line line {console | vty} Console(config-line) 23-17
Access
Control List
access-list ip standard
access-list ip extended
access-list mac
access-list ipv6 standard
access-list ipv6 extended
Console(config-std-acl)
Console(config-ext-acl)
Console(config-mac-acl)
Console(config-std-ipv6-acl)
Console(config-ext-ipv6-acl)
26-2
26-2
26-12
26-7
26-7
Class Map class map Console(config-cmap) 36-2
DHCP ip dhcp pool Console(config-dhcp) 39-6
Interface interface {ethernet port | port-channel id| vlan id} Console(config-if) 27-1
MSTP spanning-tree mst-configuration Console(config-mstp) 33-7
Policy Map policy map Console(config-pmap) 36-5
Router router {rip | ospf} Console(config-router) 42-6
42-19
VLAN vlan database Console(config-vlan) 34-5
Console(config)#interface ethernet 1/5
.
.
.
Console(config-if)#exit
Console(config)#