LevelOne GTL-2690 - Manual (Page 695)

IP Interface Commands
41-18
41
Example
The following shows the default gateway configured for this device:
Related Commands
show ip redirects (41-5)
ipv6 mtu
This command sets the size of the maximum transmission unit (MTU) for IPv6
packets sent on an interface. Use the no form to restore the default setting.
Syntax
ipv6 mtu size
no ipv6 mtu
size - Specifies the MTU size. (Range: 1280-65535 bytes)
Default Setting
1500 bytes
Command Mode
Interface Configuration (VLAN)
Command Usage
• If a non-default value is configured, an MTU option is included in the router
advertisements sent from this device. This option is provided to ensure that all
nodes on a link use the same MTU value in cases where the link MTU is not
otherwise well known.
• IPv6 routers do not fragment IPv6 packets forwarded from other routers.
However, traffic originating from an end-station connected to an IPv6 router
may be fragmented.
• All devices on the same physical medium must use the same MTU in order to
operate correctly.
• IPv6 must be enabled on an interface before the MTU can be set.
Example
The following example sets the MTU for VLAN 1 to 1280 bytes:
Related Commands
show ipv6 mtu (41-19)
jumbo frame (23-9)
Console#show ipv6 default-gateway
ipv6 default gateway: FE80::269:3EF9:FE19:6780
Console#
Console(config)# interface vlan 1
Console(config-if)#ipv6 mtu 1280
Console(config-if)#