LevelOne GTL-2690 - Manual (Page 404)

23-1
Chapter 23: System Management Commands
These commands are used to control system logs, passwords, user names,
management options, and display or configure a variety of other system information.
Device Designation Commands
This section describes commands used to configure information that uniquely
identifies the switch.
hostname
This command specifies or modifies the host name for this device. Use the no form
to restore the default host name.
Syntax
hostname name
no hostname
name - The name of this host. (Maximum length: 255 characters)
Default Setting
None
Table 23-1 System Management Commands
Command Group Function Page
Device Designation Configures information that uniquely identifies this switch 23-1
System Status Displays system configuration, active managers, and version information 23-3
Frame Size Enables support for jumbo frames 23-9
File Management Manages code image or switch configuration files 23-10
Line Sets communication parameters for the serial port, including baud rate and
console time-out
23-17
Event Logging Controls logging of error messages 23-26
SMTP Alerts Configures SMTP email alerts 23-32
Time (System Clock) Sets the system clock automatically via NTP/SNTP server or manually 23-35
Table 23-2 Device Designation Commands
Command Function Mode Page
hostname Specifies the host name for the switch GC 23-1
snmp-server contact Sets the system contact string GC 24-4
snmp-server location Sets the system location string GC 24-4
switch renumber Renumbers stack units PE 23-2