LevelOne GTL-2690 - Manual (Page 511)

Access Control List Commands
26-12
26
Related Commands
show ipv6 access-list (26-11)
show ipv6 access-group
This command shows the ports assigned to IPv6 ACLs.
Command Mode
Privileged Exec
Example
Related Commands
ipv6 access-group (26-11)
MAC ACLs
The commands in this section configure ACLs based on hardware addresses,
packet format, and Ethernet type. To configure MAC ACLs, first create an access list
containing the required permit or deny rules, and then bind the access list to one or
more ports
access-list mac
This command adds a MAC access list and enters MAC ACL configuration mode.
Use the no form to remove the specified ACL.
Syntax
[no] access-list mac acl_name
acl_name – Name of the ACL. (Maximum length: 16 characters)
Default Setting
None
Console#show ip access-group
Interface ethernet 1/2
IPv6 standard access-list david in
Console#
Table 26-4 MAC ACL Commands
Command Function Mode Page
access-list mac Creates a MAC ACL and enters configuration mode GC 26-12
permit, deny Filters packets matching a specified source and
destination address, packet format, and Ethernet type
MAC-ACL 26-13
show mac access-list Displays the rules for configured MAC ACLs PE 26-15
mac access-group Adds a port to a MAC ACL IC 26-15
show mac access-group Shows port assignments for MAC ACLs PE 26-16