IAI America FS - Manual (Page 50)

44
15) Tighten the locknut to make the tension adjustment bolts fixed.
(Use a spanner wrench of 8mm.)
16) Make an adjustment to reconstruct the home position.
1. Attach the cover on one side with the marking and move the slider to a position where the
Z-phase to be the home turns ON. It is the point 9mm away from the mechanical end for both
standard home type and reversed home type.
2. On the motor side, it should be the position of the first alignment marks.
Align the marks if they are misaligned.
Locknut
9mm
Match the alignment marks.