IAI America FS - Manual (Page 14)

8
Caution in Handling
1. Do not have the settings of speed and acceleration/deceleration exceeding
the rated values.
An operation with speed and acceleration/deceleration beyond the allowable range may
cause an abnormal noise, vibration, malfunction or shortened life.
When having an interpolating operation for combined axes, set the smallest value among
the combined axes for each of speed and acceleration/deceleration settings.
2. Set the allowable load moment within the allowable range.
Use the product with the applied load moment within the allowable range.
An operation with the load beyond the allowable load moment may cause an abnormal
noise, vibration, malfunction or shortened life. If it is extreme, flaking may occur on the
guide.
3. Set the overhang length within the allowable range.
Have the overhang length of the load within the allowable range. The overhang length
above the allowable range may cause vibration or abnormal noise.
4. Back and forth operation in a short distance may cause wear of grease.
If the actuator is operated back and forth repeatedly over a distance of 30 mm or less, the oil
film created by the grease may be broken.
It is recommended to have 5 rounds of back and forth operation in a distance more than
50mm after every 5,000 to 10,000 rounds of the short distance operation. Keep using the
actuator with the grease worn out may cause malfunction. If it is extreme, flaking may occur
on the guide.
5. Ensure use of the product in the specified conditions, environments and
ranges.
Operation out of the specified conditions could cause a drop in performance or malfunction
of the product.