Alamo Machete T 7740 - Manual (Page 12)

© 2005 Alamo Group Inc. 1-6
MACHETE
TECHNICAL INFORMATION BULLETIN No. 121495
Alamo Industrial Technical Services Department
1502 East Walnut
Seguin, Texas 78155
830-372-2708
Models:
Machete Boom Axe, Versa Boom, A-Boom, Slopemower
& Rear Mount Booms.
Date:
Dec. 14, 1995
Bulletin No:
121495
Repair Procedure for Welding Cracks in Boom Heads:
Continued Next Page
A
A
A
A
A
A
If cracks appear in the welds at points "A" as shown above, use the following procedures to
repair head.
Parts Needed:
Part No. Qty Description
02970111 2 90° Gusset
02970112 4 48° Gusset
Welding Procedure:
1. Grind a groove at the site of the crack and clean the area to be welded.
2. Weld the crack making a 100% weld.
3. After repairing the cracks, prepare the sites for installation of the gussets.
4. Position the reinforcing bar gusset part no. 02970111 if 90° or part no. 02970112 if 48° over
the X-Bar as shown in drawing next page. Weld with a 1/4" fillet weld on the bottom and an
edge weld on top. DO NOT weld the ends.
5. Clean and paint the area.
6. Reassemble any parts that were removed.