PASCO SPARK Science Learning System User's Guide - Manual (Page 12)

4 S TARTING AN EXPERIMENT
C ONNECTING SENSORS
Connecting sensors
1. PASPORT ports. 2. Temperature port. 3. Voltage port.
You can use up to two PASPORT sensors plus a temperature probe and a
voltage probe. The SPARK automatically identifies any sensor connected to it.
Complete one or more of the following tasks to connect sensors to the SPARK.
Connecting PASPORT sensors
1. Plug a PASPORT sensor into one of the PASPORT ports on the top of the
SPARK.
2. Optionally, plug a second PASPORT sensor into the other PASPORT
port.
Connecting a temperature probe
• Plug the included fast-response temperature probe (or other type of
temperature probe) into the temperature port on the top of the SPARK.