Luminex xPONENT 3.1 - Manual (Page 64)

Luminex xPONENT 3.1 Software Manual
52
click the analyte again to deselect it. You can also click and drag to select groups of
analytes. Selected analytes are red. Deselected analytes are gray. An analyte marked as
an intra-well normalization bead is blue.
Default Analysis. The default analysis changes based on the Analysis Type you
selected in the Settings tab. You can change the analysis settings for all analytes by
clicking Change if the button is enabled in this tab. This displays the Analysis Settings
dialog box.
FIGURE 32. Analysis Settings Dialog Box
If you selected Quantitative on the Settings tab, the default analysis formula is 5P
weighted. To change the default, select one of the following from the Method list:
• No Analysis
• Cubic Spline
• Linear Fit
• Logistic 4P
• Logistic 5P
• Luminex Logistic 4P
• Luminex Logistic 5P
If you select Luminex Logistic 4P or Luminex Logistic 5P, select a weight type of either
None or 1/Y
2
.
If you selected Qualitative on the Settings tab, the default analysis is Luminex
Qualitative. Change the default value by selecting either Lum Qual or No Analysis.