Agilent Technologies E1300B - Manual (Page 203)

1
Command Quick
Reference
The following tables summarize SCPI and IEEE 488.2 Common (*) commands
for the Agilent E1300/E1031 Mainframe System Instrument.
SCPI Commands Quick Reference
Command Description
ABO Rt
[IMMediate] Abort Pacer output.
D IAG nostic
:BO O T
:CO LD Restarts System processor, clears stored configurations.
[:WARM] Same as cycling power.
:CO MMunicate
:SERial[0]
[:O WNer] [SYSTem| IBASic| NO NE] Allocates the built-in serial interface.
[:O WNer]? Returns SYST, IBAS, or NO NE.
:SERial[n]
:STO Re Stores serial communication parameters into non-volatile storage.
:D O WNload
:CH ECked
[:MAD D ress] Write data to non-volatile user RAM starting at the specified address
using error correction.
:SAD D ress Write data to non-volatile user RAM at the specified address using
error correction.
[:MAD D ress] < address> , < data> Write data to non-volatile user RAM starting at the specified address.
:SAD D ress < address> , < data> Write data to non-volatile user RAM at the specified address.
:D RAM
:AVAilable? Returns the amount of RAM remaining in the D RAM (D river RAM)
segment.
:CREate < size> ,< num_drivers> Creates a non-volatile RAM area for loading instrument drivers.
:D RIVer
:LO AD < driver_block> Loads the instrument driver contained in the specified driver_block
into a previously created D RAM segment.
:LO AD
:CH ECked Loads the instrument driver contained in the specified driver_block
into a previously created D RAM segment using error correction.
:LIST
[:ALL] Lists all drivers from all driver tables (RAM and RO M)
:RAM Lists all drivers found in the RAM driver table.
:RO M Lists all drivers found in the RO M driver table.
:INTerrupt
:ACTivate [O N| O FF| 1| 0] Enable VXIbus interrupt acknowledgement.
:SETup[n] [O N| O FF| 0| 1] Enables or disables System Instrument control of VXI
interrupt line [n].
:SETup[n]? Returns current state of SETup[n].
:PRIority[n] [< priority> | MIN| MAX| DEF] Specifies the priority level of VXI interrupt line [n].
:PRIority[n]? [MIN| MAX| D EF] Returns priority level of VXI interrupt line [n].
:RESPonse? Returns response from the highest priority interrupt line.
System Instrument
Command Quick Reference 7–75