Agilent Technologies E1300B - Manual (Page 153)

:POKE DIAGnostic:POKE < address> ,< width> ,< data> writes data (number of
bits given by width) starting at address.
Parameters Parameter
Name
Parameter
Type
Range of
Values
Default
Units
address numeric 0 to 16,777,215 (# HFFFFFF) none
width numeric 8| 16| 32 none
data numeric 8 to 32 bit integer none
Comments
•
Address specifies a location within the range of the control processor’s
addressing capability.
•
Address and data may be specified in decimal, hex (# H), octal (# Q), or
binary (# B) formats.
•
CAUTION: DIAG:POKE can change the contents of any address in
RAM. Changing the contents of RAM used by the Command Module’s
control processor can cause unpredictable results.
•
Related Commands: DIAG:PEEK?
Example Store byte in User non-volatile RAM
DIAG:POKE 16252928,8,255
:RDISk:ADDress? DIAGnostic:RDISk:ADDress? Returns the starting address of the RAM disc
volume previously defined with the DIAG:RDISk:CREate command. The RAM
disc volume is defined for use only by the IBASIC option.
Comments
•
DIAG:RDISk:CREAte does not allocate the RAM volume segment until
after a subsequent re-boot. To get accurate results, execute
DIAG:RDISk:ADDRess? after the re-boot.
•
Related Commands: DIAG:RDISk:CREate, DIAG:RDISk:CREate?
Example Return the starting address of the IBASIC RAM volume.
DIAG:RDIS:ADDR?
enter statement
statement returns decimal
numeric address
DIAGnostic :POKE
System Instrument Command Reference 7-25