Controlled Products Systems Group PATRSL - Manual (Page 20)

18
SAFETY SECTION
USAutomatic gate operators are certified to UL-325 Vehicular Class I and Class II slide gate standards.
UL325 identifies four different classes of gate operators. These classes are listed below:
Class I: Residential vehicular gate operator- a vehicular gate operator (or system) intended for use in a
home of one to four single family dwellings or a garage or parking area associated therewith.
Class II: Commercial/General access vehicular gate operator- a vehicular gate operator (or system) intended
for use in a commercial location or building such as multi-family housing unit (five or more single
family units), hotel garages, retail store, or other buildings servicing the general public.
Class III: Industrial/Limited access vehicular gate operator- a vehicular gate operator (or system) intended for
use in an industrial location or building such as a factory or loading dock area or other locations not
intended to serve the general public.
Class IV: Restricted Access vehicular gate operator- a vehicular gate operator (or system) intended for use in
a guarded industrial location or building such as an airport security area or other restricted access
locations not servicing the general public, in which unauthorized access is prevented via
supervision by security personnel.
The Patriot slide gate operator is designed and intended for use on Class I or Class II vehicular gate installations.
The maximum load of each gate leaf should not exceed 600 pounds with a length not to exceed twenty-four feet.
SECONDARY ENTRAPMENT DEVICES
USAutomatic has designed all control boards with secondary entrapment device inputs and secondary safety
devices must be installed with all installations. USAutomatic recommends the use of the following devices and
has provided herein instructions for the connection of such devices. UL-325 compliant devices are
recommended. This list does not contain all devices only the ones which have been tested and recommended at
the time of printing.
NOTE: USAutomatic recommends that these devices be CONNECTED after proper gate installation and
operation has been verified. Then connect one device and verify proper operation before installing
the next device. Ensure that power is disconnected from the control board prior to connecting any
wires to the control board.
Contact Safety Devices: Safety Edges (wireless)
Manufacturer - Miller Edge
Non-Contact Safety Device: Photo Eyes
Manufacturer – EMX Industries INC.
Entrapment Alarm Devices: Sirens
Manufacturer – USAutomatic
Model Description
W12b-3
Piezoelectric siren, 108db +12vdc
NOTE: For information about installation or applications, consult factory