INTELLINET NETWORK 560801 24-Port Gigabit Managed Switch + 4 SFP Ports User Manual - Manual (Page 32)

Web Managed GbE Switch
32
Time Zone Select system time zone by hours and minutes. “+” means after-UTC and
“-” means before-UTC.
Apply Click Apply to save your changes to the switch.
3.3 Switching
Use the Switching pages to configure settings for the switch ports, trunk and other switch features.
3.3.1 Port Setting
This page allow the user to configure switch port settings and show port current status.
Click Switching > Port Setting in the navigation panel to display the screen shown below.
The following table describes the labels in this screen.
LABEL DESCRIPTION
Port Select Select the port(s) from the list box that you will change the port settings
for.
Name It allows you to give a description of the port.
Enabled Select Enable from the drop-down box to enable a port. The factory
default for all ports is enabled. A port must be enabled for data
transmission to occur. Select Disable to not use a port.
Speed Port speed capabilities:
 Auto: Auto speed with all capabilities.
 Auto-10M: Auto speed with 10M ability only.
 Auto-100M: Auto speed with 100M ability only.
 Auto-1000M: Auto speed with 1000M ability only.
 Auto-10/100M: Auto speed with 10/100M ability.