Clear-Com FreeSpeak Antenna Splitter - Manual (Page 90)

Clear-Com Communication Systems
FreeSpeak V2.0 Instruction Manual
5 - 2 0
Figure 5-43: Port Destination Select Menu
5. The port destination can be cleared by repeating the process and
selecting the ‘NONE’ entry.
If one of the headset ports (HDSTA, HDSTB) is selected the port menu
is different in the ‘KEY’ is displayed rather than ‘CALL’. This indicates
than in order to trigger an auto route from the headset to the chosen
destination the key on the basestation from panel should be used.
1. From the MAIN menu, select ‘PORTS’. A menu of the available
audio ports is displayed.
Figure 5-44: Available Audio Ports Menu
2. Select the port for which the call destination is to be set (excludes
headset ports). The menu for the selected port will be displayed.
Figure 5-45: Selected Port Menu for Calls
3. Select ‘KEY’ from the menu. The audio destination menu will be
displayed.
Figure 5-46: Port Call Menu
4. Use the Setup/Enter knob to scroll through the available ports and
select the required destination port. It is possible to select the
source port as the call destination to create an audio loopback
system. This may be used for audio testing purposes.
AVAILABLE AUDIO PORTS
PLCHB
PLCHB STGAN
STGAN PRGRM
PRGRM
BACK
4WIR4
4WIR4 PLCHA
PLCHA
AVAILABLE AUDIO PORTS
HDSTB
HDSTB 4WIR1
4WIR1 4WIR2
4WIR2 4WIR3
4WIR3
BACK
HDSTA
HDSTA
SELECTED HDSTA - HDSTA
BACK
GROUPS
LEVELS LABEL KEY
CALL DESTINATION FOR HDSTA IS NONE
BACK
NONE
NONE