Freespeak configuration editor, Introduction, Loading and saving configurations – Clear-Com FreeSpeak Antenna Splitter User Manual
Page 151: Freespeak configuration editor -1, Introduction -1, Loading and saving configurations -1, Figure 10-1 configuration editor initial screen -1
Clear-Com Communication Systems
FreeSpeak V2.0 Instruction Manual
1 0 - 1
FREESPEAK
CONFIGURATION
EDITOR
INTRODUCTION
The Cellcom/Freespeak Configuration Editor can be used to extract,
backup, edit and restore configurations from the Cellcom/Freespeak
basestations. Configurations are initially extracted from a
Cellcom/Freespeak basestation via the serial cable, and once
extracted they can be edited and either sent back to the basestation or
saved to disk for future use.
It can also be used to "clone" a basestation in case of systems failure -
all beltpack registrations and the system ID are stored within the
config.
LOADING AND SAVING CONFIGURATIONS
On loading the configuration editor should display the initial screen:
Figure 10-1: Configuration Editor Initial Screen
At this point the user has the choice of either loading a previously
extracted configuration from disk, or extracting one from a
Cellcom/Freespeak basestation.
10