Clear-Com Tempest900 - Manual (Page 70)

64 Tempest®900 2-Channel Wireless Intercom System
How Do I …?
Remove Batteries from BeltStations
Remove the battery cover from the back of the BeltStation by pressing lightly on the thumb grooves and sliding
towards the bottom. Hold the BeltStation in one hand with the battery compartment facing downward over the open
palm of your other hand. Firmly tap the BeltStation against the palm of your open hand and the battery will fall into
your open hand. Follow the same procedure for AA batteries.
Install the Rechargeable Battery
The gold battery contacts must mate with the contacts in the battery compartment. If the battery is not properly
seated, the cover will not close easily.
Charge the Battery
Connect the plug-in battery charger (included with BeltStation) to a standard wall outlet and to the Mini-USB
connector on the BeltStation. This connector is located under the rubberized access cover on the side of the
BeltStation. The batteries will charge from completely empty to a full charge in about 2¾ hours. The batteries will not
overcharge. The BeltStation remains functional during charging.
Install AA Alkaline Batteries
Remove the battery cover on back of BeltStation. Insert (3) AA alkaline batteries according to the polarization shown
inside the battery compartment. Replace the battery cover. All batteries install with the positive terminal toward the
side with Mini-USB charger connector.
Use the 5-Bay Battery Charger
Plug charger into local AC power source and place up to five rechargeable, Lithium-Polymer batteries into the
charger. Charging is complete when the indicator turns green. Re-charge time is 2½ hours and the charge provides
approximately nine hours of operation
Navigate the BaseStation Menu
Press MENU to open the Main Menu. MENU also functions as an Escape key. Turn the Volume control to scroll
through the menu. To select, press ENT or press the Volume control. The keys numbered 1 through 5 under the LCD
screen take you directly to the corresponding BeltStation menu. If no entry is made within 3 minutes, the display will
automatically return to the Operation Screen.
Navigate the BeltStation Menu
Press MENU to open the Main Menu. MENU also functions as an Escape key. Turn the Volume control to scroll
through the menu. To select, press ENT or press the Volume control. If no entry is made within a few seconds, the
display will automatically return to the Operation Screen.