Clear-Com Tempest900 - Manual (Page 13)

7 Tempest®900 2-Channel Wireless Intercom System
4. Pair BeltStations to the BaseStation
Pairing is a programming process that allows a BaseStation and BeltStation to
recognize each other.
» Confirm that the BaseStation is powered ON.
» Confirm that the BeltStation is powered OFF.
» Connect the Pairing Cable from the BaseStation to a BeltStation.
» Power ON the BeltStation and watch the BeltStation display for “Pairing
Complete.”
» BeltStation status will become visible on the BaseStation display.
» Repeat with each BeltStation.
5. Connect Headsets to BeltStations
Plug a headset into each BeltStation, and the BaseStation if desired.
6. Operation
Select a channel on the BeltStations by pressing the CH A or CH B control.
Press the TALK button. A quick press latches the Talk button for “Hands Free”
operation. Press and hold the Talk button for more than two seconds while you
talk and the button will release in a Push-To-Talk manner.
Set the volume by rotating the CH A or CH B control.
You may confirm BeltStation operation on the BaseStation Operation
screen. There is a section for each BeltStation. In this illustration, each
BeltStation is set to talk on channel A and listen on channels A & D, with
only three BeltStations in operation.
A headset may be connected to the front of the Base Station. Activate by pressing the TALK button. Select a channel by
pressing the volume knob.
Refer to the user manual for detailed instructions regarding:
» Country limitation on 900MHz RF spectrum.
» Adjusting the Network Number and Lockout Key.
» Assigning names for equipment.
» Charging batteries.